Recent Articles
Olympus X3 Saving Test Data
This article addresses saving data on the X3. To begin - As soon as a setup file is open the X3 begins recording data. If an encoder is used the data gets recorded as the encoder starts moving. If time based is used, data starts being recorded right ...
EMAT Considerations, Limitations and Things to Consider
This document seeks to inform the reader of the viability for a direct replacement of a traditional UT system by an EMAT type product. Since the traditional UT systems are well understood, and their basic technology easily accessible to both new ...
Interference signals
When encountering unusual signals it is always best to troubleshoot in a systematic way. In this case the interference noticed on the UT screen was actually caused by a bad cable on the WeldPro damaged during a more significant hit to the test head. ...
RECLAIM OPERATIONS FOR ERW MILLS
Most of our customers had to do reclaim operations at one point or another. This is usually done by a third party that arrives on site and test the many thousands of joints. The cost usually ranges from $50,000 to $80,000, for something that can be ...
Coupling Check Requirements And Differences
ASTM E273-15 does not have clear specifications when it comes to coupling checks. It does however state that 100% volumetric inspection of the weld and entire pipe length shall be made by the NDE system. This gives rise to a very important issue. How ...